AIRCAP SET #4 1.4MM FOR XPC N GXPC GUN Steel Straps 7/8" x 1/8" radius edging

7/8" x 1/8" radius edging beading bit

Can Titebond III be used for cutting boards

Is the CT118 CSA certified

Blade gauge: 0

AIRCAP SET #4 1.4MM FOR XPC N GXPC GUN Steel Straps 7/8" x 1/8" radius edging1. 4mm Aircap Set #4 Standard 1. 4mm (. 055") is installed in all Xpc Sprayguns. This air cap set is perfect for most fine finishing. Especially suitable for automotive enamels, nitrocellulose lacquers, catalyzes lacquers and latex (emulsion) where finer finish is required such as louver doors, trim, cabinets (see section above about Latex). It is also good for varnishes and oil based paints, polyurethanes. For XT Spray gun only and does not fit older